Parts Needed to Install Brake Controller in 2009 Kia Borrego with 7-Way

Question:

I have the 7 way from the factory. I was searching underneath the dash to find where I hook up the plug. I didnt see anywhere to receive the plug.

asked by: Damion W

Expert Reply:

For your 2009 Kia Borrego that has a 7-way I can help you wire in a P3 part # 90195 but we don't carry a quick install harness for your vehicle as one isn't available.

For a wiring kit to install the brake controller to the 7-way you would want the Wiring Kit for 2 and 4 Brake Electric Brake Controllers # 5506. This will provide the power source and ground for the wiring for the brake controller. You will need to test the wires from the brake pedal switch of your vehicle to find a circuit that has voltage when the brakes are applied and none when not applied. This will be the circuit you will run the red wire to.

Finally you will need to run a length of 10 gauge wire (part # 10-1-1) from the brake output circuit of the controller to the brake output circuit of the 7-way (blue wire). The # 10-1-1 is sold by the foot so you will need to order a quantity of the amount of feet you will need.

expert reply by: Jameson C