Testing Tow Ready Custom Fit Vehicle Wiring, # 118336 For Correct Functions on a 2005 Honda CR-V
Question:
I connected this up to my 2005 Honda CRV. In order to test the installtion out I purchased an LED test plug at a local auto parts store. When testing and watching the LED displays on my test plug the left and right turn indicators work. When I turn on the headlights the Light LED lights up. When I have the lights on and signal left or right the Light LED lights up but the left or right LED does not light up. Do I have a problem with the unit I installed? I have not check out the brake function but I would anticipate that both left and right indicators would light up on my test plug. and I am assuming that if I had my lights on and pressed on my brakes all 3 LEDs would light up? I hope Ive explained my situation clear enough. DoI have a problem in my wiring module? Thank you for your indulgence in this matter.
asked by: Warren
Expert Reply:
You could have a problem with the converter box in the Tow Ready Custom Fit Vehicle Wiring, # 118336, but to be sure, I would test the connector with something other than a plug in style test light. A trailer or a circuit tester like the Quickee # 3808 would be better. Some times, the plug type testers can cause a malfunction. To eliminate it as the problem another testing method will need to be done.
With a trailer hooked up, you would simply run through the functions; left, right turn signal, brakes, and running lights, to make sure they are all working properly. If they are then everything should be fine. If testing with a circuit tester, you would need to test each pin while running through the functions. If, in either case, you find that there is a problem, you will need to test the converter.
What you will do is use the circuit tester to first test the wires going into the converter box. If they are all correct, you can move on to testing the wires coming out of the converter. If the functions are correct going in but incorrect coming out then there is something wrong with the converter and it will need to be replaced. If the functions are not correct going in then there is something amiss with the vehicle wiring that probably should be checked by a qualified mechanic or a local Honda dealer.
I have included a link below to the installation details for the wiring harness for reference and a link to a video demonstrating how to test a converter.
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Towing Capacity of 2005 Honda Pilot and Parts Needed to Tow Trailer
- Q&A: What is the Difference Between the Curt & Draw-Tite Trailer Hitches For a 2006 Honda CR-V
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Wiring Harness for 2003 Honda CR-V With LED Tail Lights
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Replacement Hardware Kit Availability for Draw-Tite Trailer Hitch # 24790 for a 2000 Honda CR-V
- Q&A: How To Prevent Sag On 2004 Honda CR-V With Small Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Tow Bar Wiring: Which Wiring Kit is for You?