What Size Winch Cable Fits the Super Winch S3500 Electric Trailer Winch

Question

Question:

I have a S3500 Superwinch that came with our used trailer. What is the correct cable size for it? Thanks

asked by: Jim G

0

Expert Reply:

I had to do a little digging, but I was able to determine that the Superwinch S3500 electric winch uses 50 feet of 7/32 inch wire rope. We have 2 options in that size. First is the Fulton cable with hook # FWC7500100, with a 5,600 pound capacity. Second, we have the Dutton-Lainson Hand Winch Cable with Safety Hook, # DL24045, with a 2,500 pound capacity.

expert reply by: Michael H

0

Answer 1

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 2

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Answer 3

According to Roadmaster, the average installation time for the Roadmaster Direct-Connect Base Plate Kit #RM-521453-5 that fits your 2020 Jeep Wrangler is about three hours. That could depend on the experience though, so if it is a first-time…

view full answer...

Answer 4

Yes, the Bulldog Winch Hand Control for Truck #BDW20080 is compatible with the Bulldog Winch OE Replacement Female Plug/Wiring Harness #BDW20178C. The hand control comes with a 12 foot lead. The only other hand control option that is compatible…

view full answer...

Answer 5

The Superwinch Remote #SW87-12895 will be the replacement you need for your Superwinch Winch 2 Go Portable Winch #SW1140232. We also have the Solenoid #SW87-12893 if you want to keep an extra on hand.

view full answer...

Answer 6

Superwinch doesn't offer only the plate as a replacement part. You'd need to replace the whole socket, which is Superwinch 90-24573, our part number for it is part #SW94FR.

view full answer...

Answer 7

That is the contactor on the winch faulting out. The Replacement Contactor for Superwinch Tiger Shark Series Winches part #98-10880 will likely correct the issue you are running into.

view full answer...

Answer 8

We only carry the springs for those heavy duty style ramps. For the springs we have the Ramp Spring - 2K Torque for 1-1/2" Shaft - left hand #RS16933LH and corresponding right hand #RS16933RH. The other parts will need to be either…

view full answer...

What Size Winch Cable Fits the Super Winch S3500 Electric Trailer Winch

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching