Running Light Circuit Not Working on Trailer Connectors on a 2012 Ram 3500
Question:
On all my connector the truck the 7way in bed ,on bumper,and 4way on bumper are not getting power through the running lights I checked everything with voltage tester but I cant seem find why they not getting power for running light to work on trailer and also I plug to another everything came right on
asked by: Keith
Helpful Expert Reply:
It sounds like the tow package running light fuse is blown on your 2012 Ram 3500. On the 2012 Ram there is a trailer running light fuse in the fuse panel under the hood in location J14. Since none of the connectors on the truck have power to that circuit and the lights work fine on the trailer when connected to a different vehicle that indicates a fuse as the most likely culprit.
Product Page this Question was Asked From
- Trailer Wiring
- Trailer Connectors
- Trailer End Connector
- 0 - 5 Feet Long
- Plug and Lead
- 4 Flat
- Draw-Tite
more information >
Continue Researching
- Q&A: Does The Draw-Tite trailer Hitch Receiver Come With One Or Two Hitch Pin Holes
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Q&A: Replacement Zerk Fitting Recommendation for Dexter EZ Lube Spindle
- Article: Trailer Wiring Diagrams
- Q&A: Can 12 Volt Accessory Circuit of Trailer Wiring Keep 10 Amp Breakaway Battery Topped Off
- Q&A: Recommended Roof Rack Crossbars for Lance Cab Over Camper With Factory Tracks
- Q&A: Can You Install a 5th Wheel Hitch On a 2021 GMC Sierra 2500
- Q&A: 4-Way Trailer Connector that has 5 Wires
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Tire Sizing
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Troubleshooting 4 and 5-Way Wiring Installations