Can the Bulb in Trailer Stop, Turn and Tail Light ST8RB Be Easily Replaced
Question:
the original strongbox trailer tail light has a socket that is impossible to remove and replace the bulb. is the optronics fixture the same or a better designed bulb socket?
asked by: Bill M
0
Expert Reply:
The bulb # ST8RB trailer tail light can definitely be replaced, and to do so is not difficult. The face of the light taken off by removing four small screws, and once this is done you have access to the bulb socket and can proceed with changing the bulb.
The replacement bulb for this light would be part # A1157B.
expert reply by:
Sarah L
0
Product Page this Question was Asked From
Optronics Combination Trailer Tail Light - 6 Function - Incandescent - Red Lens - Passenger Side
- Trailer Lights
- Tail Lights
- Rear Reflector
- Side Marker
- Side Reflector
- Stop/Turn/Tail
- Square
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 5-5/16L x 4-9/16W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: Top Gifts for Dads in 2024
- Q&A: Should the Tires Lift Off the Ground While Leveling With the Lippert Ground Control Leveling System
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: Inside Diameter of Replacement Crank Extension for Lippert Spare Tire Winch Assemblies
- Q&A: How is Lippert Spare Tire Winch LC159056 Raised and Lowered
- Q&A: Weight Capacity Of Lippert Spare Tire Winch For Over sized Tire
- Q&A: Does Lippert Spare Tire Winch Lock or Hold in Any Position?
- Q&A: How Does Lippert Components Spare Tire Winch with Offset Cable Crank Up and Down
- Q&A: How To Tell If Bearing Buddy Has Enough Grease
- Article: Trailer Maintenance Schedule
- Article: 2023 Holiday Must Haves
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Wiring Diagrams