Which Trailer Hitch For a 2007 Toyota Sienna LE will Give Me the Most Ground Clearance
Question:
I own a 2007 Toyota Sienna LE and want a hitch that has the most ground clearance . it is low to the ground, are all hitches the same height? what would you recommend, i am pulling a 2500lb camper
asked by: KEN
Expert Reply:
All hitches that are made for the 2007 Toyota Sienna LE are designed to sit just below the rear bumper and are all close enough in ground clearance that it would not make a noticeable difference which one you picked. On the hitches we have installed we have found that from the ground to the top of the receiver opening is approximately 11 inches.
If you look at the picture to the right you can see a Draw-Tite Trailer Hitch for the Toyota Sienna, 2007, part # 75237 and the Curt # 13105 from a very similar angle and it shows that both are very close in ground clearance, with the Curt Hitch # 13105 maybe having a very slight ground clearance advantage.
You may also need the following:
Trailer Hitch Ball Mount 3/4 inch Rise or 2 inch Drop, part # D-4
Hitch Ball with 2 inch Diameter and Medium Shank, 6,000 lbs GTW - Chrome, part # 19247
Hitch Ball with 1-7/8 inch Diameter and Medium Shank, 2,000 lbs GTW - Chrome, part # 19260
To help with the sag on your Sienna while you are pulling a trailer you may also be interested in a Pro Series RB2 Round Bar Weight Distribution Kit with Shank, 600 lbs TW / 10,000 lbs GTW, part # 49568. I have included a weight distribution FAQ below that has some good info for you to check out.
Products Referenced in This Question
1-7/8" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 2,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 1-7/8 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 1 Inch Diameter Shank
- 2000 lbs GTW
- Class III
- Draw-Tite
more information >
2" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 7,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 1 Inch Diameter Shank
- 7500 lbs GTW
- Class III
- Tow Ready
more information >
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 675 lbs WD TW
- Visible Cross Tube
- Draw-Tite
more information >
Curt Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 1 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Drop - 2 Inch
- Rise - 1 Inch
- Fits 2 Inch Hitch
- 7500 lbs GTW
- Class III
- CURT
more information >