Will Adhesive Keep Hopkins Stick-On Graduated RV Levels in Place
Question:
Id like to avoid using screws. So wondering if the sticky tape will hold the levelers in place, without shifting over time. Someone in a review mentioned using auto decal tape instead because it was less thick and would hold them in place better than the provided tape. Any specific recommendations you might share? Thanks!
asked by: Rose
Expert Reply:
We haven't had complaints about using the included adhesive backing on level set # HM08525. If you do go with a different double-sided tape be sure to completely remove the existing adhesive. I do not foresee there being a problem but there is one thing that could cause anything that uses adhesive to loosen: heat. With a high enough temperature for a long enough period of time the adhesive will become more fluid and that could cause them to slip.
Product Page this Question was Asked From
Hopkins Graduated RV Levels - Stick-on - Qty 2
- RV Levels
- Graduated Levels
- Manual Levels
- Screw-On
- Stick-On
- RV Levels
- Hopkins
more information >
Continue Researching
- Q&A: Comparing B&W Continuum And Reese Strait-Line Weight Distribution Systems
- Article: Hard Tonneau Covers vs Soft Tonneau Covers
- Q&A: Recommended Repair For Staples That Poke Through RV Roof
- Article: How (and Where) to Connect an RV Propane Grill
- Q&A: Replacement Propane Tank Cover For A 2005 Trail Lite Hybrid Trailer
- Q&A: What Are the Mounting Dimensions on the Low Profile LED Flood Light
- Q&A: Is There an Available Exterior 110v/120v Light for 1996 Rockwood 2307 Pop Up Camper
- Q&A: Can B and W Continuum Weight Distribution be Used with Air Lift Bags
- Q&A: Front Mount Trailer Hitch Receiver Available For a 2024 Ford F-250
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: Most Popular Wheel Bearings
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 2023 Best Gifts for Outdoor Enthusiasts