Dimensions of Bottom Plate of Pro Series Snap Ring Swivel Jack Part # PS1400300303
Question:
What are the dimensions of the bottom plate? Thanks. Nick.
asked by: Nick K
0
Expert Reply:
The base plate, or foot of the Pro Series Snap Ring Swivel Jack part # PS1400300303 measures 4 by 7-1/2 inches.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Pro Series Round, Snap-Ring Swivel Jack - Bolt On - Topwind - 10" Lift - 2,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Topwind Jack
- 10 Inch Lift
- Bolt-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Q&A: Why Does My Brake Controller Light Stay On After Vehicle is Turned Off
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Does etrailer Bolt-On Swivel Mounting Plate Fit Jack TJP-5001S-B
- Q&A: Load Range D ST205/75R14 Trailer Tire With Galvanized Steel Wheel & 5 on 4-1/2 Bolt Pattern
- Q&A: Looking for a Bolt-On Jack That is Less Than 11 Inches When Attached
- Q&A: Will the Pro Series Round Snap-Ring Swivel Jack Bolt on a 2 Inch Trailer Tongue
- Q&A: Can I Pull a Trailer w/ a 2" Coupler w/ the Flint Hill Goods Trailer Dolly?
- Article: How to Measure a Trailer Axle
- Q&A: Replacement Dutton-Lainson Trailer Jack 22457 or 22560
- Article: Best RV Roof Vents
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Most Popular Wheel Bearings
- Article: Trailer Jacks
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)