Replacement Landing Gear Legs for 2007 Nitrous 5th Wheel Toy Hauler  

That's a great question. The jacks sit in the 5th wheel frame mounted clips so that the tab on the upper end of the jack leg sits under the clip, and the tab on the lower end sits above the clip, as shown in the diagram on the right-hand side of…

I recommend replacing your lead leg with one that has the same dimensions as your new follow leg, the Replacement Lead Jack w/ Drop Leg #LG-179013. This leg is 29-1/2" long, 2-1/2" wide, has a 4,000 lb weight capacity and can be used with…

I have exactly what you need to replace the driver's side (lead) landing gear leg on your trailer. Based on the 29-1/2" outer tube and 17-1/2" weld stop measurements, you are going to want to use the Replacement Lead Jack w/ Drop Leg…

You'll need to find out what brand landing gear you have on your trailer first. However, the #LG-179013 DOES work with most landing gear sets like Venture, Stromberg Carlson, Atwood and Lippert.

Sounds like you are looking for just the lead leg for the landing gear you have on your trailer. Since I do not know what landing gear you have on your trailer I attached a link to a page that has all of the lead legs we offer. You would want to…

Repair kit #LG-146059 contains 2 pins and the drive shaft all of which are for the top of the jack. To help I have included the written instructions below and also a diagram that points out the parts mentioned in the written instructions. The…

The Stromberg Carlson Replacement Lead Jack w/ Drop Leg #LG-179013 that you referenced, is a direct replacement part for jacks from Stromberg Carlson, Lippert and Atwood. It is very likely that Forest River used landing gear from one of these…

To determine if the Landing Gear #RVLG-8000 will fit your 20110 Keystone Cougar you first need to determine the distance between the weld stops on your current gear. If your weld stops (see attached picture) measure 15-1/2" on the inside and…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

If your old axles have a 5 bolt brake flange the assemblies like Dexter Electric Trailer Brake Assembly - 12" - Left Hand - 6,000 lbs part #23-105 or Dexter Electric Trailer Brake Assembly - 12" - Right Hand - 6,000 lbs part #23-106 will…

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…