Replacement Vent Lid for a Jensen RV Vent

Question:

Hi team, Im looking for a replacement vent cover for my 12.5inch X 12.5inch Jensen roof vent. I cant seem To find any online meeting these dimensions as they appear all to be 14inch X 14. Not sure if I am measuring wrong, but would appreciate any thoughts. See photos below

asked by: Phil

Expert Reply:

It is very unusual to have a roof vent with a non-standard opening.Usually the opening is 14-1/4" square, and a vent sized 14" square drops into that, and a vent lid is intalled on top of that. I would advise that you check your measurements again and see if maybe it is standard. You will also need to take a look at the hinge for your lid.

To pick the correct cover, you will also need to know the type of hinge you need.

There is a 3 point hinge, such as the one on the Camco # CAM40153; a 4 point hinge as seen on the Camco # CAM40154; or a rolled metal continuous hinge like on the Ventline # BVD0449-A03; and universal hinge as shown on the MaxxAir # MA00-335001.

Basically the easiest way to select the correct replacement cover is to remove the existing cover and match the hinge and lift bracket to the photos on our site along with the dimensions. A link to all of the replacement vent covers is provided to match up with your cover.

If it is not clear which hinge style that you have, the MaxxAir above is a Universal Replacement Lid.

In the event that you don't find a lid you like, I also included a link to our main page for our complete 14 x 14-inch vent assemblies. These are offered in manual or powered lift and with or without fans. If you install a complete new vent you'll need an installation kit, either # 344270KITW for a metal or coated metal roof or kit # CAM25013 for a rubberized roof..