Vehicle to Vehicle Tail Light Converter for LED Lights on a 2004 Infiniti QX56
Question:
I have a 2004 Infinity QX56, which uses LED brake lights and incandescent turn signals. I bought the Tow Ready 118158 before discovering that it doesnt work with my vehicle type. Is there any way to boost the signal from my vehicles 7-pin to power this product, or is there another, similar product available. My trailer uses separate brake/signals and incorporates side turn signals as well, similar to tractor trailers, all of which are LED.
asked by: Blake
Helpful Expert Reply:
You could use load resistors, # DI34ZR for 2, on the affected circuits. This will create more load on the circuits. However, while it should work in theory it hasn't been tested. So while it should work I can't officially guarantee it.
Products Referenced in This Question
Curt 2 to 3 Wire Tail Light Converter
- Tow Bar Wiring
- Splices into Vehicle Wiring
- Tail Light Converter
- Universal
- CURT
more information >
Load Resistor Kit for LED Turn Signals - 50 Watts - 6 Ohm - Qty 2
- Accessories and Parts
- Trailer Lights
- Load-Resistor Kit
- Diamond
more information >
Product Page this Question was Asked From
Vehicle to Vehicle Tail Light Converter
- Accessories and Parts
- Trailer Wiring
- Mounting Hardware
- Brackets
- 7 Round
- 7 Round
- Tow Ready
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: How to Get Separate Turn Signals and Brake Lights to Work on a Trailer
- Q&A: How to Wire a Third Brake Light on Trailer
- Article: Trailer Wiring Diagrams
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: Tow Bar Wiring Overview
- Q&A: Separating Out a Combined Brake Light and Turn Signal to Have Separate Turn Signals and Brake Lights
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Q&A: Battery Charge Line Kit Needed for a Motorhome to Towed Vehicle
- Q&A: Grease to Oil Bath Trailer Hub Conversion Kit for 3500 Pound Axles
- Q&A: How to Wire a Towed Vehicle With Seperate Turn and Brake Cicuits on Towing Vehicle
- Q&A: Getting Side Marker Lights to Function as Turn Signals and Running Lights
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide