Mounting Bracket Dimensions for the Extra Offset Trailer Spare Tire Carrier DL22145
Question:
What is the hole spacing on the mounting bracket?
asked by: Terry O
1
Helpful Expert Reply:
From left to right on the mounting bracket the hole spacings measure 3-3/4 inches. From the top holes down to the next set of holes measure 3-1/2 inches and then the closer together holes below that measure 1 inch apart.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Extra Offset Trailer Spare Tire Mount by Dutton-Lainson
- Spare Tire Carrier
- Frame Mount
- Offset Style
- 5-Bolt
- 6-Bolt
- Trailer
- 3 Inch Frame
- Dutton-Lainson
more information >
Continue Researching
- Article: Trailer Tire Sizing
- Q&A: Replacement Hub And Bearing Kit For An AL-KO 8460 Hub
- Q&A: Can Generator Be Ran While Installed on MORryde RV Generator Slide Out Tray
- Q&A: Recommended Spare Tire and Tire Carrier for Boston Whaler Boat Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Spare Tire Mounting Location on Trailer Frame
- Article: Trailer Wiring Diagrams
- Article: Printable Trailer Bolt Hole Pattern Template
- Q&A: Replacement Hand Winch Handle for my 2,500 lb. Dock Winch
- Q&A: How Far Out From the Trailer Will the Dutton Lainson Spare Tire Carrier Extend
- Q&A: Determining Towing Capacity of 2016 Toyota Highlander and Parts Needed to Tow Trailer
- Article: Performance Chips and Modules
- Article: Best Boat Trailer Jacks
- Article: How to Install E-Track in 3 Easy Steps