Installing Draw-Tite Wiring Kit # 119178KIT On A 2011 Kia Sportage EX
Question:
where do i locate the wiring harness on my kia sportage to wire my trailer with this converter?
asked by: BOB
Expert Reply:
The Draw-Tite Wiring Kit # 119178KIT will connect to the wires that are located behind the taillight assembly on your 2011 Kia Sportage.
You will have to use the included circuit tester in order to find the correct wires. First, you will access the wires behind the taillight assembly. The white wire from the converter will attach to an existing ground point or the vehicle frame. Using the included circuit tester, find the wire that carries a signal when the left turn signal is activated. Attach this wire to the yellow wire on the harness.
Next, find the wire that carries a constant signal when the vehicle lights are on. Connect this wire to the brown wire on the harness.
Then, you will need to find the wire that carries a signal only when the brake pedal is pressed. Attach this wire to the red wire on the harness.
Next, route the green wire on the harness over to the right taillight. Find the wire behind the right taillight that carriers a signal when the right turn signal is activated. Attach this wire to the green wire. Re-assemble the taillights, tuck away any loose wires, and you will be done.
I am sending a video link to this wiring kit being installed. The vehicle is different but the wiring principle is the same.
Product Page this Question was Asked From
Tekonsha Tail Light Converter with 4-Way Flat Trailer Connector and Install Kit
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- 1-1/2 Feet Long
- Universal Fit
- 4 Flat
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Install Video that Can be Used for 2007 Toyota Avalon for Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can the Bulldog Powered-Drive Kit be Used on Any Jack
- Q&A: Bulldog Powered-Drive Kit Compatibility With 12K Ram Landing Gear
- Q&A: Bypassing TIPM for Trailer Wiring Fix on 2004 Dodge Ram 1500
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Mounting the Replacement Wiring Harness For Factory 7-Way On a 2008 Toyota 4Runner
- Q&A: How Do You Disconnect Factory 7-way Connector On 2007 Toyota 4Runner To Install Hopkins HM43374?
- Q&A: Is There a Replacement for a Trimark 030-0900 Door Latch
- Article: Trailer Wiring Diagrams
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Measure the Bolt Pattern of a Trailer Wheel
- Article: Flat Towing Package for 2014-2018 Jeep Grand Cherokee