Will the etrailer Round, Snap-Ring Swivel Jack # TJBB-2001-B Fit on a 2 inch by 5 inch Trailer Frame
Question:
Only one more question. Please let me know the retracted dimension from the center of the mounting bracket to the bottom of wheel. I only have 12 inches max.
asked by: Joe V
Expert Reply:
We have several options for a bolt on swivel jack for your trailer with 2 by 5 inch frame (see link). I would recommend the Pull Pin, Easy Swivel Trailer Jack with 8 inch Wheel - Sidewind - 1,500 lbs. by Dutton-Lainson, item # DL22800, for your trailer if the 1500 pound capacity is sufficient for your boat and trailer. These jacks are high quality and designed to fit square tongues up to 3 x 5 inches.
The etrailer Round, Snap-Ring Swivel Jack - Bolt On - Topwind - 10 1/2 inch Lift - 2,000 lbs, item # TJBB-2001-B, is not designed to fit on frames higher than 4 inches tall. At this time we do not have a swing up jack for 5 inch tall frame that has a 2,000 pound capacity.
Products Referenced in This Question
Pull Pin, Easy Swivel Trailer Jack with 8" Wheel - Sidewind - 1,500 lbs. by Dutton-Lainson
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- Dutton-Lainson
more information >
Product Page this Question was Asked From
Round Snap Ring Swivel Jack w/ Footplate - Bolt On - Black - Topwind - 10-1/2" Travel - 2K
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Swivel Jack
- Topwind Jack
- 10 Inch Lift
- Bolt-On
- With Rectangle Foot
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Oil Seal for 10K Quality Axles with Seal 27438
- Q&A: Recommended Replacement For A Dometic Duo-Therm Rooftop Unit
- Article: The Differences Between Cam Buckles and Ratchet Straps (And Who Would Win In a Fight)
- Article: Trailer Tire Sizing
- Article: How to Store a Travel Trailer/Camper for the Winter
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Q&A: Protective Case for NOCO Boost X Jump Starter
- Q&A: What is the Distance from the Pipe Mount to the Bottom of the Leg on the Trailer Valet JXS Jack?
- Q&A: Does the Galeo Ride GPS Tracking Device for Bikes Come with Everything Needed
- Q&A: Replacing A Lippert A-Frame Jack For A Side-Mount Swivel Tongue Jack
- Article: How to Measure a Trailer Axle
- Q&A: What Exactly Does a 6 on 5-1/2 Inch Wheel Bolt Pattern Mean
- Article: Tire TLC: How & When to Check Your RV/Trailer Tire Pressure
Joe
10/25/2010
Only one more question. Please let me know the retracted dimension from the center of the mounting bracket to the bottom of wheel. I only have 12 inches max.