Size of Center Section on Kodiak Disc Brake Kit # K2HR712 That Rims Has to Fit Over
Question:
Code: K2HR712 Can you please give me the center bore size of this disk brake hub. I just like to make sure make rims sits perfectly on the hubs. If they are loose little bit, would you have any rings to on hubs to make it hub centric? Thank you
asked by: Jack U
0
Expert Reply:
The center section of the hubs on the Kodiak Disc Brake Kit # K2HR712 that you referenced where the pilot hole of a rim would have to fit over is 4-3/4 inches. That would have to match you wheel perfectly if they are hub centric wheels. We do not offer rings to take up room there.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Kodiak Disc Brake Kit - 13" Hub/Rotor - 8 on 6-1/2 - Raw Finish - 7,000 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 7000 lbs
- Brake Assembly
- 8 on 6-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What Brake Fluid Is Required For Hydrapro Alpha G-1600X Electric Over Hydraulic Actuator Disc Brakes
- Q&A: What is Difference Between Hydrastar and Hydropro Brake Actuators
- Q&A: Parts Needed To Convert Trailer From Electric Drum Brakes To Electric Over Hydraulic Disc Brakes
- Q&A: How to Measure Brake Drums
- Q&A: Correct Disc Brake Conversion Kit for 2022 Grand Design Momentum 397THS
- Q&A: Do I Really Need To Repack Bearings Every 12 Months If I Have Low Mileage On Trailer
- Q&A: Comparing the HydraStar Hydraulic Actuator and the Titan BrakeRite Hydraulic Actuator
- Article: Adding Electric Over Hydraulic Disc Brakes
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: Most Popular Wheel Bearings
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Performance Chips and Modules
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer