Is There A Wiring Adapter To Install Draw-Tite Activator IV Brake Controller On 2003 Hummer H2
Question:
I already have a drawtite activator 4 brake control box from my old vehicle. Do you sell the adaptor for installaton in my 2003 hummer h2? Can you tell me where to find where to plug in the adaptor?
asked by: jeff
Expert Reply:
Yes, the adapter you will need to install the Draw-Tite Activator IV Brake Controller on your 2003 Hummer H2 is the Universal Brake Control Wiring Adapter, part # 3015-S. You will need to match the corresponding colored wires to the color wires coming out of the brake controller. You will want to twist the exposed wire and connect each wire individually with the included butt connectors. Then, wrap each connection in electrical tape. The other end of the adapter will plug into the port located under the dash of your Hummer near the emergency brake.
If you do not have a factory 7-way on your Hummer you will need to install Replacement Multi-Tow 7-Way and 4-Way, part # 30955. To install part # 30955, use the included mounting bracket to mount at the rear of your Hummer, and the harness will plug into the existing vehicle harness located above the spare tire.
Products Referenced in This Question
Tekonsha Custom Wiring Adapter for Trailer Brake Controllers - Pigtail - GM
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Wired to Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Replacement Custom Multi-Tow 7-Way and 4-Way Trailer Connectors
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- 7 Round - Blade
- Hopkins
more information >