Correct Ball Mount for a 1995 Buick Riviera
Question:
I purchased a drawtite hitch for a 1995 buick Riviera and I already had a draw bar ballmount and I am unable to make it fit. is this design have a tappered draw opening. and if so what ballmount will work for the class 2hitch
asked by: Joel
Expert Reply:
I am not sure which draw bar you have, but the recommended draw bar for your vehicle and trailer hitch is the Class II Draw bar 3-1/8 inch Rise, part # 36061. None of the hitches or draw bars we carry have tapered receivers or shanks, so the only thing I can think of is that you have a Class 1 hitch and a Class 2 draw bar which are not compatible with each other even though they have the same 1-1/4 inch by 1-1/4 inch shank.
.
The Class 2 shank will not fit in a Class 1 hitch, but a class 1 shank will work in a Class 2 hitch, provided you take tongue weight and gross trailer weight into consideration.
Products Referenced in This Question
Draw-Tite Drawbar for 1-1/4" Hitches - 3-1/8" Rise - 11-3/4" Long - 3,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Rise - 3 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Class II
- Draw-Tite
more information >
Product Page this Question was Asked From
Draw-Tite Drawbar for 1-1/4" Hitches - 3-1/8" Rise - 9-3/4" Long - 3,500 lbs
- Trailer Hitch Ball Mount
- Fixed Ball Mount
- No Ball
- 3/4 Inch Ball Hole Diameter
- Steel Shank - Gloss Black
- Rise - 3 Inch
- Fits 1-1/4 Inch Hitch
- 3500 lbs GTW
- Class II
- Draw-Tite
more information >
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: My Trailer Hitch Doesn't Fit
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Hitch and Wiring Recommendation for 2018 Ford Focus ST Hatchback
- Article: How to Choose a Cargo Carrier That Will Clear a Rear Mounted Spare Tire or Bumper
- Q&A: What Kind of Hardware Should I Use For My Trailer D-Ring Tie Downs?
- Q&A: Locating Factory Weldnuts on 2003 Volvo V70 to Install Curt Trailer Hitch # C12318
- Q&A: Can Trailer Hitch Extender hes0 Be Used for Towing with a 2007 Ford Explorer
- Q&A: Will the Wiring Harness # C59496 Fit on a 2006 Volvo XC70
- Q&A: Trailer Hitch for a 1997 Toyota Camry LE