Distance from Pin Hole to Center of Ball Hole on Reese Light Duty Weight Distribution System

Question

Question:

Specifically how far from center of hitch ball to center of receiver pin hole... Thanks.

asked by: Bw

0

Expert Reply:

I spoke with my contact at Reese and he informed me that the dimension you are looking for from the hitch pin hole to the center of the ball hole is 11-3/4 inches. He also mentioned that since the angle of the head changes depending on how it's set up this dimension can vary slightly.

expert reply by: Jameson C

0

click to enlarge

Answer 1

I see that you referenced quite a few weight distribution systems including the Reese Steadi-Flex kit #RP66558. For this kit's included shank the distance from the center of the hitch pin hole on the shank to the near edge of the two welded…

view full answer...

Answer 2

Whether or not you need a weight distribution hitch for you Lance 1475 depends on several things. 1. Is the trailer weight more than 50 percent of your vehicle's weight? 2. Is the rear of your tow vehicle sagging when the trailer is hooked up? 3.…

view full answer...

Answer 3

Weight distribution heads are adjustable to get the spring bars level or just below level with the trailer frame. Depending on the trailer frame, the head may need to be set at 90 degrees, it also may need to be tilted down as far as possible to keep…

view full answer...

Answer 4

I agree, the bag for the NOCO Boost X Jump Starter #NOC88VR is a nice way to keep everything together but it definitely lacks in the protective department. To keep your Boost X Jump Starter safer you'll want to pick up the EVA Protection Case…

view full answer...

Answer 5

On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…

view full answer...

Answer 6

To replace your Dometic Duo-Therm 13,500 BTU rooftop unit I recommend the Furrion Chill Replacement RV Air Conditioner 15,000 Btu - White #FR42PV. This unit comes with an adapter cable which will allow you to plug right in to your existing air…

view full answer...

Answer 7

The weight distribution system that has the best sway control and is properly rated for your tongue weight that will be between 450 and 500 lbs is the Reese Strait Line part #RP66083. This would be my first pick as your best option as it has a tongue…

view full answer...

Answer 8

For a trailer that has an angle iron frame like what you have what I would recommend is a system like the Reese Steadi-Flex part #RP66558 you referenced and have the outer brackets welded to the frame of the trailer since there isn't a clamp on…

view full answer...

Answer 9

For your 2024 Toyota Sienna Platinum you will need a 7-way connection along with the brake controller itself. I recommend the following: -Curt Powered Tail Light Converter #C59236 -Universal Installation Kit for Trailer Brake Controller #ETBC7…

view full answer...

Answer 10

Hey Dennis, we have a replacement 7-way plug with the part #A7WCB which would work great to replace your damaged one. I attached a diagram for 7-ways for you to check out as well.

view full answer...

Distance from Pin Hole to Center of Ball Hole on Reese Light Duty Weight Distribution System

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching