Grease Dust Cap Recommendation for Kodiak Disc Brake Kit K2HR712
Question:
will it fit kodiak K2HR712 disk brake rotor? if not which one will fit
asked by: Rafael
0
Expert Reply:
For hubs that have 8 wheel studs and 7k capacity like the part # K2HR712 the grease cap size needed is 2.72 inch so you would need the part # rg04-120.
expert reply by:
Jameson C
0
Products Referenced in This Question
Kodiak Disc Brake Kit - 13" Hub/Rotor - 8 on 6-1/2 - Raw Finish - 7,000 lbs
- Accessories and Parts
- Trailer Brakes
- Disc Brakes
- LH
- RH
- 7000 lbs
- Brake Assembly
- 8 on 6-1/2
- Hub and Rotor Assembly
- Kodiak
more information >
Grease Cap, 2.72" OD Drive In with Plug - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- E-Z Lube Grease Cap
- 2.717 Inch O.D.
- Redline
more information >
Product Page this Question was Asked From
Grease Cap, 2.44" OD Drive In with Plug - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- E-Z Lube Grease Cap
- 2.441 Inch O.D.
- TruRyde
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Most Popular Wheel Bearings
- Q&A: Replacement Hub And Bearing Kit For An AL-KO 8460 Hub
- Article: Trailer Wiring Diagrams
- Q&A: Will The Kodiak Disc Brakes # KOD69FR Fit Load Rite Boat Trailer With 5,200LB Torsion Axles?
- Q&A: Replacement Motor for a 676062 RV Step Motor
- Article: Trailer Tire Sizing
- Q&A: Timken Replacement Bearing Solution for Setup with Part Numbers L44649 471750 L44610
- Article: How to Tell the Weight Rating of a Trailer Axle
- Q&A: Recommended E-Z Lube Hub and Rotor Assembly for 6K Axles
- Q&A: How to Determine Correct E-Z Lube Grease Cap
- Q&A: Lug Nut Torque Chart for Trailer Wheels
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Bleed Your Trailer Surge Brakes
- Article: How Much Does a Boat and Trailer Weigh?