Will the Yakima HullyRoller Kayak Carrier Work with Fiberglass and Composite Kayaks

Question

Question:

Looking at the Yakima Handroll roof rack kayak system. I see that you do not recommend for fiberglass kayak. I have a composite. Will it work? Why not recommended for fiberglass? Thanks

asked by: Bruce D

1

Helpful Expert Reply:

I spoke with my contact at Yakima and she said they no longer have any exclusions for the HandRoll # Y04082 with fiberglass or composite kayaks. Yours will work just fine.

expert reply by: Jameson C

1

Answer 1

The etrailer Kayak Carrier w/ Tie-Downs #e98878 fit crossbars measuring up to 3-1/8" wide x 1-1/2" tall, so since your square crossbars are a little taller we need to go with a different solution, and for that I recommend the Class 2 from…

view full answer...

Answer 2

The big difference between the two trailers is the EcoLight trailers like part #MAL43FR were made to be lighter weight for smaller vehicles and have lower weight capacities. This weighs 145 lbs and has a 400 lb capacity whereas the MicroSport…

view full answer...

Answer 3

I spoke to my contact at Rhino Rack and he informed me that the length of the roller on the Rhino Rack Ladder Roller #RR1500 that you referenced is 56-1/4 inches. Check out the picture I attached to see this measurement.

view full answer...

Answer 4

Thanks for the picture! I just spoke with my rep at Yakima and got some specifications and dimensions off of the Yakima BigCatch Kayak Carrier item #Y04091 you referenced. It is 9-1/4" x 6-1/2" x 5-1/2" and has a weight capacity of 150…

view full answer...

Answer 5

I took a look at your order and it was the Rhino-Rack Roof Rack for Factory Tracks - 54" Bars #Y02-480B-NT which is too short for the 63 inch spacing on your truck. For that spacing you will need the following: - Rhino-Rack Roof Rack for Factory…

view full answer...

Answer 6

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 7

That's a 4-way connector in your picture and what comes with the Malone MicroSport LowBed Trailer #MPG464-LB. The fourth pin is the ground circuit and the other three carry the signals for the circuits.

view full answer...

Answer 8

I recommend the RetraxPRO XR Hard Tonneau Cover #RTT-80485 and Yakima OverHaul HD Adjustable Truck Bed Ladder Rack #Y01151-5955 as the best combination for your 2024 GMC Sierra 3500 long bed. The ladder rack will mount to the t-slot channels in the…

view full answer...

Answer 9

Yes, it does! The PowertraxPRO XR Hard Tonneau Cover item #RTX84QR is confirmed to fit the 2024 GMC Sierra 3500 with a 6-3/4' bed. The slots built into the cover are compatible with Yakima ladder racks like the OverHaul HD Adjustable Truck Bed…

view full answer...

Answer 10

Furrion had to come up with an adapter for their Vision S systems like the part #FOS07TASF with the part #FR87PR which fixes the problem that your truck has with this camera setup.

view full answer...

Will the Yakima HullyRoller Kayak Carrier Work with Fiberglass and Composite Kayaks

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching