What Size Wire Should be Ran Through a Trailer to Power a Roof Vent Fan
Question:
Im going to prewire my trailer Im building for a electric fan . what size wire should I use?
asked by: Ron R
0
Expert Reply:
The wiring used on vent fan motors for trail vents like # V2119-603-00 is not very large so I would not go any larger than 16 gauge like # 16-1-1 sold by the foot.
expert reply by:
Michael H
0
Products Referenced in This Question
Product Page this Question was Asked From
Ventline Ventadome Roof Vent w/ 12V Fan - Powered Lift - 14-1/4" x 14-1/4" - Smoke
- RV Vents and Fans
- Vent
- Roof Vent
- Powered Lift
- 4-1/2 Inch
- 12V Fan
- Reversible Fan
- 14W x 14L Inch
- Plastic and Metal
- Tinted
- Ventline
more information >
Continue Researching
- Q&A: Roof Vent for a StarCraft Pop Up Camper
- Q&A: Recommended In-Bed 7-Way Connector for a 2024 Chevy Silverado 2500
- Q&A: Replacement Control Kit for Power Gear 500457 Module
- Q&A: Thule Awning FIt for Forest River Travel Trailer
- Q&A: Replacement Mounting Hardware for Dometic 310 Part-Timer RV Toilet
- Q&A: Power Roof Vent That Wires To Switch Plate
- Q&A: Direct Replacement for Ventline Ventadome Roof Vent Model 2119
- Article: How to Replace or Install an RV Roof Vent
- Article: How to Replace an RV Roof Vent Cover
- Article: Trailer Wiring Diagrams
- Article: Best Air Bag Suspension (2023)
- Article: Flat Towing Package for 2015 Ram 1500
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Roadmaster Vehicle Specific Base Plates