Ladder That Can Be Trimmed to fit Winnebago Minnie
Question:
I would like to install a ladder on my Minnie. From the roof to the lower mounting point is only around 78 inches. The dimension shown for the LA-401 is 92 inches, can i remove an entire step to make this work?
asked by: Lew R
1
Helpful Expert Reply:
You can cut the bottom of the ladder legs off on the # LA-401 to allow you to customize the length that you would need.
This will allow the ladder to be able to be used on your Minnie.
I attached a review video for this ladder for you to check out as well.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Stromberg Carlson Exterior RV Ladder - Aluminum - 99-1/2" Tall - 250 lbs
- RV Ladders
- Exterior Ladders
- Aluminum
- 8 Feet Tall
- Silver
- Stromberg Carlson
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement RV ladder for 2007 Monaco Diplomat
- Q&A: How Much Upward Bend Should Trailer Axle Have
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Q&A: Replacement Disc Brake Caliper for a Tie Down Engineering 46304 Caliper
- Q&A: Replacement For Dexter DX12.5 Brake Actuator on Boat Trailer
- Q&A: Which Lift Kit Fits 2010 Forest River R-Pod 172 with Lippert 3,500 Torsion Axle
- Q&A: How Far Back Should Thule Mounting Feet Be Placed On a 2019 Toyota Highlander with Bare Roof
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Electric Bikes
- Article: How to Choose a Hitch-Mounted Bike Rack
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: RV Pre-Departure Checklist