Will The Curt Hitch C13082 Fit a 1990 Chevy Silverado 1500 Short Bed Step Bumper
Question:
Hi. I have a 1990 Chevy Silverado 1500 with a 6ft bed. Single cab. The back bumper is a step up model. The spare tire is bolted under the bed not far from the back bumper. From what I see in the Installation PDF Im thinking this hitch receiver will fit my truck, but thought Id better pass it by you first before ordering. Thank you for your help.
asked by: Kellie C
Helpful Expert Reply:
The Curt hitch part # C13082 that you referenced is a fit for your 1990 Chevy Silverado 1500 short bed that has a step bumper. You would also be able to keep your spare tire as well. At worst you might have to reposition it as you raise and lower the spare.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 600 lbs TW
- 6000 lbs GTW
- 10000 lbs WD GTW
- 2 Inch Hitch
- 1000 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Disc Brake Caliper for a Tie Down Engineering 46304 Caliper
- Q&A: Recommended Replacement for Imperial 55 Inch Side-Door Bar Lock
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Article: How to Replace or Install an RV Roof Vent
- Q&A: How Do I Measure the Drop Distance on a Trailer Drop Axle?
- Q&A: Replacement For Dexter DX12.5 Brake Actuator on Boat Trailer
- Q&A: Hitch for 1997 Chevy K1500 That Wont Interfere w/ The Spare Tire In Any Way
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Can You Flat Tow a Ford Escape?
- Article: Trailer Maintenance Schedule
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 2023 Holiday Must Haves