Replacement 12 inch by 2 inch Brake Assemblies for 6k Axle that Use 4 Bolt Mounting Pattern
Question:
Hi, I have a Kiefer Built horse trailer with a HammerBlow Corp. axle. The nameplate on the axle reads 6000lb rated, and it has 12x2inch brakes. The drum is a 6 on 5 1/2inch bolt pattern, and the axle has the 4-bolt mount. The backer plate measures the same as a few other replies I read in the QandA section, 3.125inch on top, 2.5on bottom, and 3.375inch between top and bottom holes. The center hole is 3 17/32inch just under 3 9/16. The only reason I am asking this is I havent read that dimension in any other posts, and I want to make sure that these will fit my application before ordering. I believe the 5-bolt backers have a center dimension of 3 8/32inch just over 3 1/4, which is too small for this axle.
asked by: Caleb M
Expert Reply:
We have the brake assemblies you are looking for. The only 6k rated 12 by 2 inch assemblies we offer that have the same unique 4 bolt mounting patter are the # 23-106-09 for the right hand side and part # 23-105-09 for the left hand side.
Products Referenced in This Question
Dexter Electric Brake Assembly for 4 Bolt or 5 Bolt Flange - 12" - Right Hand - 6,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- RH
- 6000 lbs
- Brake Assembly
- Manual Adjust
- 12 x 2 Inch Drum
- Dexter
more information >
Product Page this Question was Asked From
Dexter Electric Brake Assembly for 4 Bolt or 5 Bolt Flange - 12" - Left Hand - 6,000 lbs
- Accessories and Parts
- Trailer Brakes
- Electric Drum Brakes
- LH
- 6000 lbs
- Brake Assembly
- Manual Adjust
- 12 x 2 Inch Drum
- Dexter
more information >
Continue Researching
- Q&A: Weight of 21K Demco Hijacker AutoSlide 5th Wheel Hitch
- Q&A: Best Upgrade for Dometic 310 Part-Timer RV Toilet
- Q&A: How To Connect A Dometic 310 RV Toilet To A Supply Line That's Too Far Away
- Q&A: Typical Trailer Suspension Hanger Spacing Relative to Leaf Spring Size
- Q&A: Torque Specs for 3500-lb 5-on-4-1/2 Dexter Hub/Drum 84546UC3
- Q&A: How Close Does Trailer Ball Height Need to be to the Height of the Trailer Coupler
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Q&A: Repair Kit Fulton Wedge-Latch # F670801, Fits Fulton/Bulldog Couplers for 2-5/16 Inch Balls
- Article: Harvest Hosts
- Article: Trailer Tire Sizing
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Where to Position the Trailer Axle?
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: How to Measure a Trailer Axle