Bearings Needed For 1 Inch Diameter Spindle
Question:
I lost the old bearings, so no numbers. The spindle is 1inch but I dont know what BT8 is. The id of the hub is 2. do you think this bearing kit will work for me? Also how does one measure a tire? 13inch 14inch etc.
asked by: William C
Expert Reply:
I did some research, and wasn't able to determine what BT8 actually means or where the term came from. Perhaps it was the stock number of the original spindle of that size.
If your spindle is 1 inch in diameter, and not tapered, the #BK1-100 bearing kit you mentioned is probably the one you need. You can confirm this by knocking out the inner and outer bearing races and looking at the reference numbers. If the races are marked L44610, the # BK1-100 is the correct bearing kit.
I'll link you to an FAQ article about measuring tires. If you look at the tire size molded into the tire sidewall, the last two digits of the tire size are the wheel diameter. For instance, a ST175/80-13 tire would have a 175mm tread width, a section height that's 80% of the 175mm width that's mounted on a 13 inch wheel.
Product Page this Question was Asked From
Bearing Kit for 1" BT8 Spindle, L44643 Inner/Outer Bearings, 34823 Seal
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- Bearing Kits
- Bearing L44643
- Race L44610
- 2000 lbs Axle
- 2500 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Where to Measure on Trailer Spindles to Determine Replacement Hubs
- Article: How to Raise Your Travel Trailer Height
- Q&A: Recommended Replacement for Atwood Surge Brake Actuator 85778
- Q&A: Recommended Replacement AC Unit For A Coleman Mach On A 2000 Mesa Pop Up Camper
- Q&A: B&W 4 Inch Offset Gooseneck Ball for a 2015 GMC Sierra 2500 Short Bed
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: What is Difference Between Trailer Bearings L44649 vs L44643
- Q&A: Replacement Hub and Drum Assemblies for AL/KO 8460 Hubs and Drums
- Article: Pintle-Hitches
- Q&A: Replacement Zerk Fitting Recommendation for Dexter EZ Lube Spindle