Is Trailer Brake Mounting Flange part # 4-44-1 Sold Individually

Question

Question:

Are the axle flanges sold in pairs. Or individual

asked by: Troy H

0

Expert Reply:

The Brake Mounting Flanges part # 4-44-1 that you referenced are sold individually. If you needed a pair you would need to order a quantity of 2.

Be sure to have a qualified fabricator with experience in installing flanges install them.

expert reply by: Jameson C

0

Answer 1

To determine if there are compatible hubs and associated bearings to replace your current hubs to a more standard size you will have to take several precise measurements on the spindle of your axle. It is recommended to use a set of dial calipers to…

view full answer...

Answer 2

On the Redline Brake Mounting Flange, part #4-44-1, the five bolts are press fit into the flange. To be removed they would have to be pressed out with a hydraulic press. Once they are pressed out the bolts are not to be used again. So you would not…

view full answer...

Answer 3

Absolutely, in order to install a 5 bolt brake mounting flange, you will need the Brake Mounting Flange for 3" Round Axle part #4-44-1. This brake flange bracket is designed to work with an axle diameter of 3". If your axle is smaller than…

view full answer...

Answer 4

I reached out to my rep at Dexter, and unfortunately we cannot identify your axle with that provided axle tag/serial number. With that being said, we can narrow down what axle you have by looking for specific information available. For example, if…

view full answer...

Answer 5

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

view full answer...

Answer 6

When brakes are adjusted out properly there will be a slight but constant drag of the pad material on the rotor or drum. If the brakes are actually being applied then there is either an electrical issue with the actuator #K71-651 or something wrong…

view full answer...

Answer 7

Torsion axles use internal rubber cords to provide the suspension motion and they really are not practical to repair/rebuild. Certainly any axle that was damaged in an accident should be replaced purely for safety reasons. It is potentially possible…

view full answer...

Answer 8

It does indeed point upward. The axles are designed so that they're upward arched in the center so that then the axle is under load, the contact patches of the tire treads will sit flat on the pavement. Without the arch or camber, the axle beam…

view full answer...

Answer 9

Bearing #2788 has an inner diameter of 1.50-inches and fits race #2729. Bearing #1779 has an inner diameter of 0.938-inches and fits race #1729. We do offer all of these bearing and race parts and if you wish you can install new bearings in your…

view full answer...

Is Trailer Brake Mounting Flange part # 4-44-1 Sold Individually

Product Page this Question was Asked From

Continue Researching