Is There Cutting of Fascia Required to Install Curt Class I Hitch on 2007 G35X
Question:
Is any cutting required for installation for a 2007 G35X, or is this operation 100 bolt on?
asked by: Ben
Expert Reply:
Yes, cutting of the fascia is required for installation of Curt Class I Trailer Hitch, part # C11499, on your 2007 G35X. You will drill two holes under the license plate to install the part # C11499. These holes are cut to get access to lower bolts in fascia. The license plate will cover up the holes cut when re-installed. You will also need to cut a small square from the fascia on the bottom of the fascia to make room for the hitch to fit. This is underneath and not seen. Check out the attached video to see this completed.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Aluminum Fascia Support on 2009 Infiniti G37 is Welded On and Cant Install Trailer Hitch
- Q&A: 2012-2013 Infiniti G37 Sedan Hitch and Bike Rack Recommendation
- Q&A: Hitch Recommendation for a Infinity G37X
- Q&A: Does Bumper Fascia Spacer Need to Be Reinstalled on 2013 Infiniti G37 When Installing Curt Hitch
- Q&A: Replacement Hub/Drums and Brake Assemblies for Trailer with 5,200 lb Axle
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What Does S-Class Mean in Reference to Vehicle Tire Chains
- Q&A: What Does Class S Mean For Snow Tire Chains
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Bike Racks for Fat Bikes
- Article: Trailer Hitch Receiver Sizes
- Article: Best Bike Racks for Electric Bikes