Dimensions Of Reese Sway-Control Bracket for 2 Inch Ball Mounts

Question:

I was wondering if you could give the dimensions of the plate and holes? Distance from center to center and offset center to center. Looking at possibly have one made with steel I have so I can use with dual friction bars. Thanks,

asked by: Matt

Helpful Expert Reply:

The hitch ball and friction sway bar ball holes on the Reese Sway-Control Bracket measure 5-1/2 inches apart center on center. I've attached a photo including some other measurements I took on this bracket for you.

An easier solution to accommodate 2 friction sway control bars is to use 2 weld-on tabs # 3442 with your ball mount. The Curt Ball Mount with Sway Control Bracket # D320 has one sway control bracket already welded on to the ball mount. This ball mount offers 3/4 inches of rise or 2 inches of drop. With this ball mount, you would only need to weld 1 bracket on the other side to use 2 friction sway control bars.

If you already have a ball mount with the correct rise/drop for your trailer, you can just purchase 2 of these tabs # 3442 to allow you to mount 2 friction sway control bars on the ball mount.

If you need a ball mount, I've linked all of our ball mounts for you, as well as a help article on choosing the correct rise/drop/

expert reply by: Victoria B