Is there Drilling Required to Install Curt Hitch 13138 on a 1998 Mazda B Series
Question:
Is there any drilling for a 1998 Mazda B series truck?
asked by: Scott
0
Expert Reply:
Some of the vehicles this hitch will fit require drilling and some will not. This hitch uses 4 bolts. On all trucks at least 2 of the holes are present and on some trucks all 4 are present.
At the most you would have to drill two 1/2 inch holes, but you can use the hitch as a template to assist the process. I spoke with one of my contacts at one of our hitch manufacturers an it appears the 2nd pair of holes started appearing in 2002, so you will most likely have to drill. I have added a link to the instructions below for you to review.
expert reply by:
Patrick B
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: 2003 Ford Ranger Hitch Receiver Recommendation
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Will the 6 on 5-1/2 Kodiak 12" Rotor item # KR12S Replace a 12” UFP Brake Rotor?
- Q&A: Recommended Trailer hitch Receiver For a 2008 Ford Ranger 4x4
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended Trailer Hitch Receiver for 2004 Ford Ranger Edge
- Q&A: Replacement Disc Brakes, Bearings, and Actuator for 2010 EZ Loader Boat Trailer
- Q&A: How Can I Identify an Axle Without a Sticker?
- Q&A: Can a Double-Lip Trailer Hub Seal be Used in Place of a Single Lip Seal
- Article: Frequently Asked Questions About Transmission Coolers
- Article: Which Hitches are Made in the USA
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Flat Towing Package for 2008-2011 Honda CR-V