What is the Mounting Hole Diameter for the Erickson tie Down Anchors EM09095
Question:
What metric diameter panhead screw is goingto fit the holesin the anchor plate?I just ordered the the loops
asked by: Steve B
0
Expert Reply:
You would want to use countersunk screws since the holes in the Erickson tie down anchors # EM09095 are countersunk. I went out to the warehouse and pulled one of these anchor sets to measure the diameter of the hole width for the head and threaded part of a screw. For the threaded part of the screw use a 5mm. The countersunk head can be as large as 8.75mm in diameter. A 9mm diameter head would be too large for the screw head to sit flush with the top of the anchor.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Erickson Stainless Steel Truck or Trailer Anchor (2 Pack) - 1,200 lbs
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Tie-Down Cleats and Rings
- 1200 lbs
- Rope Ring
- Erickson
more information >
Continue Researching
- Q&A: Recessed D Ring Recommendation for Securing 4k Vehicle to Enclosed Car Hauler
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Printable Trailer Bolt Hole Pattern Template
- Q&A: Replacement Hardware for a Receiver Hitch on a 2022 Mazda CX-5
- Q&A: Recommended Torque Wrench for Trailer Hitch Installation
- Q&A: Which Post of Starter Solenoid - SPST Is Ground
- Q&A: Lug Nut Torque Rating Recommendation for Tightening the Kenda Wheel and Tire # AM30040
- Q&A: Can Bunk Brackets Work as Replacements for Welded On Supports
- Q&A: Comparison of Steel vs Aluminum Trailer Wheels?
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Slipper Spring Trailer Suspension System Review