Mounting Hole Dimensions for the Lunette Ring with 4 Hole Base # C48550
Question:
Can you provide drawing for hole placement? Only lists one dimension. 63023
asked by: Justin K
0
Expert Reply:
I contacted the manufacturer and found that the mounting hole dimensions of the Lunette Ring with 4 Hole Base, item # C48550, are 4-1/2 inches up and down and 4-1/2 inches left to right. The holes are 5/8 of an inch in diameter. They use the hardware kit # C48332.
I attached a diagram with these dimensions for you to check out as well.
expert reply by:
Jameson C
0
click to enlarge
Products Referenced in This Question
Curt Bolt Kit for Flat Mount Lunette Ring
- Accessories and Parts
- Lunette Ring
- Hardware
- Bolts
- CURT
more information >
Product Page this Question was Asked From
Curt Lunette Ring - Flat Plate Mount - 2-1/2" Diameter - 35,000 lbs
- Lunette Ring
- Standard Coupler
- Coupler Only
- Bolt-On
- 35000 lbs GTW
- 2-1/2 Inch Lunette Ring
- CURT
more information >
Continue Researching
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Hanger Spacing for 3500 LB. Tandem Axle Trailer
- Article: What is the Best Trailer or RV Storage Cover
- Q&A: 10K Torsion Axle Compatibility With Disc Brakes
- Q&A: Heavy Duty Trailer Hitch Receivers For 1989 Chevrolet C/K Crew Cab Pickup
- Q&A: Length of Equalizer 013-105-04 in Dexter Heavy Duty Suspension Kit # K71-360-00
- Q&A: Replacement Landing Gear Motor for Venture M-9000-PK Motor and Replacement Aluminum Gearbox
- Q&A: Could GO Power Solar Panel kit part # 34273836 Mount to Pin Box and Use SAE Port
- Q&A: Curt Triflex Brake Controller Displays 05 and Trailer Brakes Not Working with Brake Pedal
- Article: Trailer Tire Sizing
- Article: How to Choose a Battery Charger
- Article: Trailer Wiring Diagrams
- Article: How to Accurately Measure Trailer Leaf Springs