Trimming Rubber Channel In Bottom Of Vortex Aero Crossbars For Roof Rack
Question:
On the length strip on Rhino Rack 2500 do you trim the strip up to the 0zero mark before cutting to the specified length ? the edge is rounded and is appx 1/8 inch from zero mark to the end ? will the excess make a big difference? I cut the strip to 135mm from zero the the mark however as I said its about an 1/8 inch to the end. Thanks
asked by: Steve G
Helpful Expert Reply:
I called my contact at Rhino Rack and asked about trimming the rub er strip you asked about on the 2500 bars.
They told me if it says to cut 135mm, then you just need to cut at the 135mm mark and you should not worry about measuring 135 from the end with the excess 1/8 inch of material.
Product Page this Question was Asked From
Rhino-Rack Vortex Aero Crossbars - Aluminum - Silver - 59" Long - Qty 2
- Roof Rack
- Crossbars
- Aero Bars
- 59 Inch Bar Space
- 2 Bars
- Overhang
- Silver
- Rhino Rack
more information >
Continue Researching
- Q&A: 2019 Dodge Grand Caravan Permanent Install Roof Rack
- Article: Rooftop Cargo Carriers
- Q&A: How to Pick Out Wind Fairing for Roof Rack on Vehicle
- Q&A: What is Difference Between Top and Bottom Infill for Yakima Overhaul HD Bars
- Q&A: Comparison of Rhino-Rack Heavy-Duty and Rhino-Rack Vortex Aero Roof Racks
- Q&A: Dimensions Of The Bottom Infill for Yakima HD Crossbars # Y01166-LC
- Article: Roof Rack Information
- Q&A: Comparing Thule AeroBlade Crossbars vs WingBar Evo Crossbars
- Q&A: Recommended Roof Rack for Sky One-Touch Power Top on 2020 Jeep Wrangler Unlimited
- Article: How to Choose the Right Trailer Hitch Class
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: How to Install a Roof Rack
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)