Recommended Brake Controller and Wiring Harness for a 2002 Roadtrek on a 2002 Chevy Chassis
Question:
I need a brake control that will work with my 2002 Roadtrek on a 3500 chevy also 2002 I am towing a two axle trailer with brakes
asked by: Richard H
Expert Reply:
I can help you to get your Roadtrek up and ready to tow your trailer with a brake controller and wiring.
First lets start with the brake controller. I highly recommend the Tekonsha P3 # 90195, because it is a proportional brake controller which means it senses how the tow vehicle is slowing or stopping and applies the trailer's brakes with the same intensity. It also has a full display screen instead of codes that need deciphering. The P2 # 90885 is like the P3's little brother, it has all the great qualities but won't have the display screen.
There is no plug and play port for the Roadtrek, so you will want to hardwire it for a brake controller. If you have a 7-way already run on your Roadtrek then you will only need to hardwire in the brake controller with the # 5506 kit.
If you already have a 4-way you will need to hardwire in the 7-way kit # ETBC7. Some models may have a round plug with a cap on the inside of the drivers frame rail for the 7-way, if you have this then your will need the # 30955 and # 5506. Vehicles with the 7-Way tow package have the blue output brake wire already ran from the back to the front. It is located under the dash near the emergency brake pedal. If your Roadtrek does not have any wiring you will need to install a 4-way like # C56175 and then the # ETBC7.
To complete a towing setup you will need a ball mount and ball. The specific ball mount will depend on your trailer and vehicles needs, I have linked an article to help you determine what you will need. The ball you will need will depend on your trailer but the two most common sizes are the 2 inch like the # 63845 and the 2-5/16 inch like the # 63840.
I have linked all the above mentioned parts as well as a few Help Articles and an installation video on a similar vehicle for your convenience.
Products Referenced in This Question
Replacement Custom Multi-Tow 7-Way and 4-Way Trailer Connectors
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 4 Flat
- 7 Round - Blade
- Hopkins
more information >
Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
2-5/16" Hitch Ball - 1-1/4" Diameter x 2-3/4" Long Shank - Chrome - 20,000 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2-5/16 Inch Diameter Ball
- 2-3/4 Inch Shank Length
- 1-1/4 Inch Diameter Shank
- 20000 lbs GTW
- Class IV
- Class V
- Draw-Tite
more information >
2" Hitch Ball - 1" Diameter x 2-1/8" Long Shank - Chrome - 7,500 lbs
- Trailer Hitch Ball
- Trailer Hitch Ball
- Standard Ball
- Chrome-Plated Steel
- 2 Inch Diameter Ball
- 2-1/8 Inch Shank Length
- 1 Inch Diameter Shank
- 7500 lbs GTW
- Class III
- Tow Ready
more information >
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Curt Tail Light Converter with 4-Way Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Universal Fit
- 4 Flat
- CURT
more information >
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Does the Tekonsha P3 Trailer Brake Controller Turn Off or Stay On All the Time
- Q&A: Parts Needed To Install A Brake Controller On A 2023 Freightliner Cascadia
- Q&A: Suspension Enhancement Recommendation for 2019 Toyota RAV4
- Q&A: Parts Needed to Add 7-Way & Brake Controller on 2023 Kia Sportage
- Q&A: My Vehicle has a 4-Pin Trailer Plug, but Trailer has 7-Pin Trailer Plug
- Q&A: Comparison of Tekonsha Prodigy P3 and Primus IQ Brake Controllers