Parts Needed to Install a Brake Controller and 7-Way in a 2013 Toyota Tacoma
Question:
I need to install a 7 pin connector and brake controller on my 2013 Tacoma. I will be purchasing the ETBC7 installation kit along with the Tekonsha Prodigy P2 Trailer Brake Controller. I previously installed a 4 pin harness, so I believe I am set to go. Before I order the parts from you folks, I have a few questions. Would I need a plug-in adapter for the brake controller, or do I use the ETBC7 kit to wire direct to the controller? Would I need to configure an isolation relay to insure that the battery in my camper trailer does not drain my Tacomas battery when the ignition switch is turned off? Would appreciate any expert assistance you are able to provide. Thank you,
asked by: Robert S
Helpful Expert Reply:
You are on the right track. To install a brake controller in your 2013 Toyota Tacoma will first require a 4-way like the part # C55513 and then the # ETBC7 to convert it to a 7-way so that you can install the # 90885 brake controller. There isn't an plug in adapter available for your truck.
To prevent the trailer from draining your truck battery you can unplug the trailer connector or you can install an isolation solenoid like part # PK5231201.
Products Referenced in This Question
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Grounded
- Accessories and Parts
- Battery Boxes
- Switches and Solenoids
- 100 Amp
- Pollak
more information >
Product Page this Question was Asked From
Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires
- Accessories and Parts
- Trailer Brake Controller
- Installation Kits
- etrailer
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Where Do the Wires on the Universal Install Kit for Trailer Brake Controllers Get Installed?
- Q&A: 2022 Toyota Highlander Wiring for a 7-Way Blade Connector
- Q&A: Should I Get a Proportional or Time-Delayed Brake Controller
- Q&A: Parts Needed to Tow Trailer With Brakes Using 1992 Dodge D250
- Q&A: 4-Flat Trailer Wiring For 2024 Jeep Wrangler With Tow Bar Wiring