Base of Flange to Top of Ball Dimension on Equal-i-zer Weight Distribution Ball EQ91-00-6080

Question

Question:

What does this 2 inch diameter trailer ball measure from Base of Flange to Top of Ball? Thanks

asked by: Bill S

1

Helpful Expert Reply:

I was able to go out to our warehouse and measure this for you. I found that from the flange to the top of the ball platform is 3.033 inches.

I have linked an image of this measurement for your convenience.

expert reply by: Jackie C

1

click to enlarge

Answer 1

I spoke with my representative at Equal-i-zer and the grooves that you see at the top and bottom of the spring bar receiver on the head is normal wear. He also mentioned that keeping the receiver lubricated will help reduce on wear in the future, but…

view full answer...

Answer 2

Because your trailer is a straight-tongue or pole-tongue trailer, you will need a pole-tongue adapter like #RP58393. For a weight distribution system, I recommend Reese Steadi-Flex Weight Distribution with Sway Control part #RP66561. This system is…

view full answer...

Answer 3

Yes, Equal-I-Zer actually makes a 2 inch hitch ball for use with their weight distribution systems which is part #EQ91-00-6080. This would work well with the part #EQ37060ET if that is the kit you have.

view full answer...

Answer 4

For a 2 inch hitch ball that fits the Equalizer Weight Distribution systems we have the part #EQ91-00-6080. You should note that this has an 8,000 lb trailer weight capacity though.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 8

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 9

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 10

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 11

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 12

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Base of Flange to Top of Ball Dimension on Equal-i-zer Weight Distribution Ball EQ91-00-6080

Product Page this Question was Asked From

Continue Researching