Replacement Landing Gear Follower Leg for a 2010 Keystone Fusion 5th Wheel Trailer
Question:
Will this replacement follow leg landing gear fit on my 2010 keystone fusion 322 hauler ? it looks like the same one I removed
asked by: Bruce W
0
Expert Reply:
The landing gear on your 5th wheel trailer is likely made by Lippert. Check the motor/lead leg to see if there is any indication of the manufacturer.
If it is a Lippert system and the old follow leg has an outer tube height of 29-1/2 inches then this is the correct replacement follow leg.
If you come up with a different manufacturer or outer tube measurement let me know.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Replacement 5th Wheel RV Landing Gear Follow Leg w/ Snap Pin for RVs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Legs
- Follow Leg
- Lippert
more information >
Continue Researching
- Q&A: Difference Between Landing Gear Follow Leg Replacements # LC119101 and # LC179014
- Q&A: Replacement Follower Leg for a Venture VMC900L Landing Gear Set
- Q&A: Replacement Landing Gear Drop Leg And Pull Pin For 5th Wheel Trailer
- Q&A: Replacement Landing Gear Legs Needed for a 2004 Arctic Fox 29.5E 5th Wheel Trailer
- Q&A: Recommended 5th Wheel Hitch Compatible with CMI 5th Wheel Rails
- Q&A: Comparing Lippert Landing Gear Motor # LC196308 and Stromberg # LG-196308
- Q&A: Lippert Solera Power Awnings 672050 Replacement Drive Head
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Measure for Trailer Hitch Drop
- Article: The Best RV Battery Chargers
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: How Much Solar Power Do I Need For My RV?