Troubleshooting Both Trailer Turn Signals Coming On With Right Blinker
Question:
There is problem when I turn right Bothe signal are on and when I press the break the signal light is on in the trailer
asked by: Ahmed
0
Expert Reply:
Sounds like you have some of your trailer wires shorted out to each other. You will need to go over the wiring of the connector on your tow vehicle and trailer to find the short between the two and fix as needed.
I attached a couple help articles on troubleshooting trailer wiring for you to check out as well.
You can also try improving the grounds of the lights to see if that helps too. Sometimes insufficient grounds cause all sorts of weird behavior.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Both Trailer Turn Signals Blink at the Same Time
- Q&A: All Trailer Lights Blink When One Turn Signal Is Activated
- Q&A: Trailer Turn Signals Both Blink at the Same Time When Right or Left Turn Signal is Turned On
- Article: How to Measure for Trailer Hitch Drop
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: How to Increase the Clearance Between the Truck Bed Rails and the Bottom of a 5th Wheel Trailer
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Tip for Difficult to Engage Tool of Rhino Rack Pioneer Platform 2022 Toyota RAV4
- Q&A: How To Shift A 2021 Jeep Wrangler Transfer Case Into Neutral To Flat Tow
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com