Can Brass Fittings of the Camco RV Winterization Bypass Kit Be Attached to Aluminum w/o Corrosion
Question:
Any problems threading brass fittings into an aluminum water heater causing corrosion?
asked by: Fred
0
Expert Reply:
Dissimilar metals like brass and aluminum will eventually corrode if left together for extended periods of time. These two metals typically take years for the aluminum to corrode. The plumbers tape that comes with the # CAM35953 is designed to protect the metals from contacting each other. If you use enough of the tape you wouldn't have any contact and would be just fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Camco RV Winterization Bypass Kit w/ 8" Hose for 6 Gallon Water Heater - Permanent
- Accessories and Parts
- RV Water Heaters
- Winterization
- Permanent Bypass Kit
- Camco
more information >
Continue Researching
- Q&A: Can The RAS And SumoSprings Be Installed At The Same Time?
- Q&A: Replacement Pin Box for a 2022 Keystone Cougar 5th Wheel
- Q&A: Is Parts Diagram Available for Lippert Electric Trailer Jack
- Q&A: Troubleshooting Lippert Electric Stabilizer Jack Not Working
- Article: How Much Solar Power Do I Need For My RV?
- Q&A: Solution for Needing Replacement Slide Out Motor # 8532-18HT
- Q&A: How to Fix Rapid Turn Signal Flashing On a Vehicle
- Q&A: Replacement Parts for Fan-Tastic Vent 8000 Series
- Article: The #1 RV Roof Maintenance Tip: Keep it Clean (Here's How)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Which Hitches are Made in the USA