Troubleshooting Clicking Landing Gear on RV After New Landing Gear Motor
Question:
I have a question I have replaced the motor on my landing gear and the new motor does the same loud clicking noise I have the new gear reduction box just have not put it on yet.any advise
asked by: Brian B
0
Expert Reply:
The load clicking is most likely an insufficient ground for the landing gear motor or that the amperage draw for the landing gear is greater than what the power source can handle. Or it is that you are overloading the weight capacity of the landing gear.
Most likely it's just a bad ground though.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Motor for Stromberg Carlson Electric Landing Gear - 5,500 lbs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Motor and Gear Parts
- Motor
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Replacement Motor for Atwood 75721
- Q&A: Replacement Motor and Gearbox for Atwood 75721
- Q&A: 5th Wheel Landing Gear Clicks and Won't Go Up or Down
- Q&A: Recommended Replacement Landing Gear Motor on 2007 Keystone Raptor Toy Hauler
- Q&A: 5th Wheel Landing Gear Motor Makes Loud Clicking Noise and Will Not Raise Trailer
- Q&A: Replacing ADTH 1RV-200 Landing Gear Motor
- Q&A: Recommended Replacement Venture Landing Gear Motor and Gearbox for 2008 Forest River Sandpiper
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Best Landing Gear
- Article: How to Mount a Truck Bed Camper
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)