Backup Camera with No-Splice Installation in 2014 Ram 1500
Question:
I am trying to wire a back up camera and dont want to splice the wiring. There are several kits that would T the connection...I need both +12, ground, and back up lights for the camera...I am not sure which kit to buy. Also on the other end of the truck I know there is a place to pull wires through the cab...Thanks.
asked by: Dan J
Expert Reply:
A backup camera system like the Hopkins Smart Hitch # HM50002 does use a T-connector at your truck's existing 7-way trailer socket to connect to its 12V, ground and reverse circuit wiring that operate the camera. When you shift the vehicle into reverse that lighting circuit activates the camera and monitor automatically.
If you needed to access the +12V circuit in order to wire in an additional backup light such as # BUL002CB, you could simply tap into the +12V wire on the T-connector using a quick splice fastener # SWC501915-1.
Products Referenced in This Question
Optronics ONE LED Backup Light for Truck or Trailer - Submersible - 1 Diode - Oval - Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Oval
- Recessed Mount
- Submersible Lights
- LED Light
- 6-1/2L x 2-5/16W Inch
- White
- Optronics
more information >
Quick Splices - Self-Stripping Connector - Closed Port - 10-12 Gauge - Yellow - Qty 1
- Wiring
- Wire Connectors
- Quick Splice Connectors
- 12-10 Gauge
- Spectro
more information >
Product Page this Question was Asked From
Hopkins Smart Hitch Backup Camera and Hitch Aligner System
- Backup Camera
- Hitch Alignment Camera Systems
- Hardwired
- Dash Monitor
- 3.5 Inch Display
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Maintenance Schedule
- Q&A: My Firestone Compressor Keeps Running Even When Air Bags Are Full
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Size Wire Gauge is Used in Vision X 9007 Halogen Headlight Bulbs with Relay Harness
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Parts Needed To Install Trailer Brake Controller For a 2006 Toyota Tundra With Factory 7-Way
- Q&A: Parts Needed to Swap a Trailer With Surge Brakes to Electric Brakes
- Q&A: 2018 Ram 1500 Firestone Ride Rite Air Bag Kit Recommendation
- Article: Performance Chips and Modules
- Q&A: How To Select The Correct MORryde AllTrek Equalizer For a Tandem Axle Trailer
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Can You Convert Tie Down Engineering LP8500 from Disc to Drum