Bolt-Through Hardware Kit for Fulton Swivel Jack
Question:
Does this part work for a 2000 lb. Fulton swivel jack?
asked by: John
0
Expert Reply:
The bolt-through hardware kit for Fulton swivel jacks, part # F0933325S00, fits all bolt-through Fulton swivel jacks regardless of capacity. This fits a mounting plate like part # P9012-00 as is found on jacks like # FXP10.
expert reply by:
Adam R
0
Products Referenced in This Question
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Bolt-On
- With Wheel
- Fulton
more information >
Jack Mounting Bracket for Fulton Marine Jack - Weld-On
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Fulton
more information >
Product Page this Question was Asked From
Replacement Hardware Kit for Fulton Swivel Jacks
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Fulton
more information >
Continue Researching
- Q&A: Sleeve Washer for Fulton Swivel Jack to Prevent it From Leaning
- Q&A: Size of Bolt Needed for A-Frame Jacks
- Q&A: Hardware Typically Used to Install A-Frame Trailer Jack
- Q&A: Is My Trailers Frame Strong Enough To Use A Weight Distribution Hitch
- Q&A: Replacement Jack For A Dorsey Boat Trailer
- Q&A: Trailer Hub that Uses Bearing # LM67048 for Inner and Outer
- Q&A: What Trailer Tire Size is Most Similar in Diameter to 7-14.5 for Trailer
- Article: Best Boat Trailer Jacks
- Article: Flat Towing Package for 2014-2015 Chevrolet Equinox