Hole Dimensions on Polar Strap Hinge for Enclosed Cargo Trailer Doors 2512
Question:
Just need to know the size of the holes - the three going across and the two on the actual side strap? Please. I need to go buy the bolting hardware and I need to know what sizes and depth/length...
asked by: Charlee F
Expert Reply:
I went to our warehouse to check the dimensions for the mounting holes on the Polar Strap Hinge for Enclosed Cargo Trailer Doors # 2512.
The two holes on the smaller end of the hinge measure 0.4-inches (10mm) and the three holes on the larger end measure 0.34-inches (8.5mm) in diameter.
Since this item is galvanized you'll want to use galvanized hardware (or stainless steel) for installation on your trailer.
Product Page this Question was Asked From
T-Strap Hinge for Enclosed Trailers - 12" Long - 180 Degree Rotation - Zinc Plated Steel
- Trailer Door Hinges
- Strap Hinge
- T-Strap
- Steel
- 12 Inch Long
- 2 Inch Wide
- Bolt-On - Pre-Drilled Holes
- Polar Hardware
more information >
Continue Researching
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Height Dimensions Of The Z-Rail for Enclosed Trailer # 362417-955
- Article: Where to Position the Trailer Axle?
- Q&A: Replacement Strap Hinge for Back Door on Featherlite Trailer
- Q&A: Availablity Of Replacement Ramp Door Spring For 94 Door That Weighs 140lbs
- Q&A: Inside Channel Dimension of H-Channel for Enclosed Trailer
- Article: Best Camper Jacks
- Q&A: Replacement Door Parts for Featherlite Trailer
- Q&A: Should There Be a Washer on Trailer Spindle Between Spindle Nut and Outer Bearing
- Q&A: What is Most Common Trailer Wheel 6 Lug Bolt Pattern
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)