How is the Bulldog Jack part # BD180304 Lubricated
Question:
Where is the Zerk fitting in the bulldog 7200 pound top wind jack with leg?
asked by: Cody
0
Expert Reply:
Actually the Bulldog Jack part # BD180304 does not have a zerk fitting but I can tell you how Bulldog recommend you lube this jack.
Bulldog recommends you apply a lightweight oil to the screw stem like in the picture I attached.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Bulldog Square Jack w/ Footplate - Drop Leg - Topwind - 20-1/8" Lift - 7,200 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 7001 - 8000 lbs
- Topwind Jack
- 20 Inch Lift
- Weld-On
- With Rectangle Foot
- Bulldog
more information >
Continue Researching
- Q&A: Will The Lippert Spare Tire Winch # LC159056 Fit In Place Of BAL Retract-A-Spare?
- Q&A: Solution to Making Charging Dump Trailer Battery from Tow Vehicle Battery as Efficient as Possible
- Q&A: Pipe Mount Weld On Swivel Jack With Built in Grease Fitting
- Q&A: Can Two Square Direct Weld Jacks 25-3/4 Lift - 10K Be Used Together
- Q&A: Comparing the Square Direct Weld Jack TJD-12000SP-F2 and TJD-12000SP-R2
- Q&A: Are the Trailer Wheel and Tire Combinations Balanced
- Article: Trailer Jacks
- Q&A: Weight Distribution Availability with Ice Castle Fish House
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Hitch Receiver Sizes
- Article: Testing Breakaway Systems
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Determining Trailer Tongue Weight