Replacement Step Pad for Westin Signature Series Nerf Bars on a 1999 Ford F-250 Crew Cab
Question:
I am missing a step pad on the running boards of my 1999 F-250 Ford Crewcab Diesel Truck. The pad seems to measure about 3X19.5 inches and have 2 mounting holes. I need 1 pad and mounting clips with directions for install.
asked by: David C
Expert Reply:
The Westin step pads for their nerf bars are going to have more than 2 mounting holes. Based on the measurements you have provided replacement pad # 25-0001 is the best match. It mounts in 4 holes. The barrel slips are included.
Installation is easy. Remove the old pad and clips. Put the new clips on the mounting posts on the bottom of the pad. Press the pad (posts with clips on them) into the holes on the top of the bar. I would also step on it a few times to make sure it is fully seated.
Products Referenced in This Question
Replacement Step Pad for Westin Signature Series Nerf Bars - 19-3/4" Long - Qty 1
- Accessories and Parts
- Nerf Bars - Running Boards
- Step Pad
- 4 Pegs
- 19-3/4 Inch Long
- With Clips
- Westin
more information >
Product Page this Question was Asked From
Replacement Step Pad for Westin Oval Tube Steps - 18" x 4" - Rear - Qty 1
- Accessories and Parts
- Nerf Bars - Running Boards
- Step Pad
- 5 Pegs
- 18 Inch Long
- With Clips
- Westin
more information >
Continue Researching
- Q&A: Replacement Step Pads for Nerf Bars on 2007 Chevrolet Silverado
- Q&A: Need 4 x 23-5/8 5 Pin Replacement Step Pads for Aries 4 Inch Step Bars
- Q&A: Diameter of Pegs on Westin Replacement Step Pad
- Q&A: Barrel Clips Measurement To Determine Compatibility with Nerf Bars
- Q&A: Replacement 21 inch by 3 inch Nerf Bar Pad Recommendation
- Q&A: Where to Attach Red Rocker Switch Wire on Superwinch LT2000
- Q&A: How Do I Determine What Nerf Bars Are On My Truck