Installation Instructions for Halogen Docking Light Kit, # DL-16CC.
Question:
need wiring diagram for these lights
asked by: Fabian
Expert Reply:
I can certainly provide you some installation instructions for the Halogen Docking Light Kit, # DL-16CC.
First, drill a hole at the desired mounting locations, slip on the rubber boot cover, then install the lights using the included hardware. Disconnect the battery to avoid short circuits/electrical shock. Measure the wire needed to install the lights on your boat and cut the red wire into the lengths needed. Place the plastic terminal covers onto the wire and attach the corresponding metal terminals.
Mount the switch in a convenient location. Then, snap the wiring together. Reconnect the battery. Finally, loosen the bolt on the side of each light, adjust the beam to the desired level, and re-tighten securely.
Product Page this Question was Asked From
Halogen Docking Light Kit - 35 Watt - Lighted Switch and Safety-Fused Wiring - Black Housing
- Boat Lights
- Docking Lights
- Deck
- Black Housing
- Surface Mount
- Halogen Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Replacement LED Flood Light for Load Lights on a Horse Trailer
- Q&A: Work Flood Light Fitment for 3-1/2" Wide x 2-1/4" High Spacing
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Check Valve Replacement for Lippert Hydraulic Slide Out
- Q&A: Interior and Exterior Horse Trailer Light Recommendations
- Q&A: LED Flood Light Recommendation for the Sides of a Horse Trailer
- Article: Trailer Wiring Diagrams
- Q&A: Dimensions of Lens for Optronics Halogen Utility Light
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Recommendations for Spare Wheel on 1965 Lil Loafer Trailer
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)