Recommended 12-Ft Extension Hose For Propane Tank To Use On Generator

Question

Question:

You have a 12 foot hose, CAM59825. I would like to use this as an extension going from a fixed propane bottle and connect with my generator hose. The referenced hose has a tank connector to screw on outside of tank connector. Question: Will the other brass connector mate with my existing hose that has a screw on tank connector. Basically, does this hose have a female and male connector that would connect to propane tanks and provide an extension?

asked by: Bill K

0

Expert Reply:

If your generator has a connector that uses a 20 or 30-lb refillable propane tank, then the Camco Propane Hose Assembly, part # CAM59825 would work for you.

This hose has a Type 1 ACME nut that will connect to your propane tank. This is a 12-ft long hose.

expert reply by: Jeffrey L

0

Answer 1

To connect your Champion #100165 Dual Fuel generator to a 100 pound propane tank, the manufacturer states that "The generator can be attached a larger propane tank. The generator requires ½ PSI with a flow rate of 152,000 BTU/hr.…

view full answer...

Answer 2

I actually like your first idea better because we have trailer vents that you can install on your door to help keep water spray away from the internal components. Our selection ranges from battery box vents like part #A10-3300BK-05 to ventilator like…

view full answer...

Answer 3

Yes, you are correct. In order to correctly take this measurement you will need to measure from the center of the spindle to the center of the main axle tube. I have included a picture for reference.

view full answer...

Answer 4

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 5

On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…

view full answer...

Answer 6

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 7

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 8

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Recommended 12-Ft Extension Hose For Propane Tank To Use On Generator

Product Page this Question was Asked From

Continue Researching