Recommended Type & Size of Installation Hardware for Optronics Side Marker Light MC32AB
Question:
It is very helpful that you noted the 3inch on center between the mounting holes. Could you also suggest a screw type, size and length as well as a pilot drill bit size? These would be really helpful in the specifications part of web page.
asked by: Ken P
Expert Reply:
The type and length of mounting screw to use to install the Optronics Trailer Clearance or Side Marker Light # MC32AB will depend largely on the nature of the mounting surface. If there is wood behind the trailer's outer skin at the mounting point then use wood screws long enough to securely grab that material. If the underlying material is metal then use sheet metal screws. If you are using existing holes in the trailer then that may determine the size of fastener you need to use.
The two mounting holes in this light are indeed spaced at 3-inches apart center-to-center as you noted. I went to our warehouse and pulled a sample so that I could give you the actual hole diameter to help you choose the right diameter hardware. The two holes in the light base are 1/4-inches (6.6mm) in diameter. You can choose your preferred hardware and drill bit sizes accordingly. A 3/16-inch diameter screw and a 5/32-inch drill bit should be good.
Product Page this Question was Asked From
Trailer Clearance or Side Marker Light w/ Reflex Reflector - Rectangle - Amber Lens - White Base
- Trailer Lights
- Clearance Lights
- Rear Clearance
- Side Marker
- Rectangle
- Surface Mount
- Non-Submersible Lights
- Incandescent Light
- 4L x 2W Inch
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Does B and W Gooseneck Hitch # BWGNRK1217 Fit 2017 Nissan Titan XD Long Bed
- Article: Trailer Wiring Diagrams
- Article: Trailer Tire Sizing
- Q&A: Looking for Replacement Trailer Lamp Lens # 1A-S-20
- Article: Trailer Lighting Requirements
- Article: Most Popular Wheel Bearings
- Q&A: Best Replacement for Micro-Flex 349 Trailer Clearance Light
- Q&A: How to Make Espresso While Camping
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Q&A: Recommended Replacement 3- Step Electric RV Steps
- Q&A: Replacement For Lippert 143701 Klauber F-350 Slide-Out Motor
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: 2023 Best Gifts for Auto Enthusiasts