How Does the Backing Plate of the Base Plate # 118-3 Install in Geo Tracker Frame
Question:
u slide the tubing on the 118-3 into the tubing on the frame then drill 1/2 inch hole in frame for the bottom of the 118-3 .How do u get the small late past the tubing because the tubing goes threw frame blocking room to slide the small plate back in the frame to bolt into The tubing goes threw both frames!
asked by: Gary
0
Expert Reply:
I checked the install instructions for the Roadmaster Base Plate Kit part # 118-3 that you referenced and in it they recommend removing the base plate from the frame once you drill the holes so that you can then insert the threaded backing plates and then the base plate itself.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Universal Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Hitch for a 2024 Toyota Grand Highlander
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Availability Of Trailer Wiring Harness For A 2024 Toyota Grand Highlander
- Article: My Trailer Hitch Doesn't Fit
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Parts Needed to Install 7-Way/4-Way on 2024 Kia Telluride with LED Taillights
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: What Does the Curt Hitch Look Like When Installed on a 2024 Toyota Grand Highlander?
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Q&A: Does Curt Hitch C12130 Fit 2008 Mercury Grand Marquis