Troubleshooting Trailer Connector And Wiring On 2012 Chevrolet Colorado
Question:
I have a 2012 Chevy Colorado and had UHAUL install a 7-way connector for a travel trailer. Everything works correctly except the brake lights dont work on the trailer. I understand that my truck has separate wires for the brake lights and turn signals. Im told I need some type of a splitter box but dont know what I need. I have a brake controller because my travel trailer has electric brakes so Im not sure if the brake light wire would connect to the same connection as the brake controller wire.
asked by: Larry L
Expert Reply:
When a 7-way connector was installed on your Colorado, a converter should have been included because the vehicle has separate lighting meaning the brake signal and turn signals are sent along separate wires. It sounds like the wiring kit was not installed correctly.
For your 2012 Colorado, I recommend a wiring harness like part # 118301. This harness plugs into the truck wiring under the truck bed on the driver side.
I recommend using a circuit tester like part # PTW2993 and test the 7-way connector pins for function. If you are not receiving the brake signal from the appropriate plug, I recommend returning to the installers and have them correct the installation.
You should follow the wiring from the connector back to the truck and see if a converter is wired in place. Test the green, yellow, and red wires coming out of the converter box to see if they show current when the brake pedal is pressed.
If the wires from the converter and the pins on the connector are receiving the signal, you will need to use a 12V power source like a car battery and test the trailer connector as well. Attach the ground wire from the trailer connector to the negative post and use a circuit tester as a type of jumper from the positive post to the wires or pins on the connector. Look for any loose or damaged wires on the trailer and also check for any signs of corrosion on any of the pins.
I have attached a link to a helpful article about trailer wiring you can check out. In the article it has wiring diagrams and also shows how a vehicle side and trailer side plug should be wired.
Products Referenced in This Question
T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- Tekonsha
more information >
Product Page this Question was Asked From
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Troubleshooting Lack of 12V Power at 7-Way Trailer Connector on 2019 Ford F-150
- Article: Trailer Lighting Requirements