How to Remove Curt Q16 Head from Center Section
Question:
I just purchased a Curt Q16 5th wheel hitch. I pulled the large center pin to remove the head but cannot get the head to separate from the bottom frame. Am I missing something or is it just that tight? Thanks,
asked by: Jay U
Expert Reply:
No need to worry, Typically it's harder to remove the head after use. I double checked the instructions that I've linked for your convenience, and they state it is only the lynch pin and large pivot pin that need to be removed to remove the head. They do recommend the head and legs be removed as one unit and say that if there is binding they recommend loosening the four 14mm leg mounting bolts to release them from the rails.
Product Page this Question was Asked From
Curt A16 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
- Fifth Wheel Hitch
- Fixed Fifth Wheel
- Above Bed Rails
- 4000 lbs Vertical Load
- 16000 lbs GTW
- Cushioned Double Pivot
- Standard - Double Jaw
- 13 - 17 Inch Tall
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Gooseneck to 5th Wheel Adapters
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Ram Trailer Tow Prep Package
- Q&A: Does Adding An Air Bag Kit Increase My Towing Capacity?
- Q&A: Will Curt A16 5th Wheel Trailer Hitch Fit Reese Base Rails
- Q&A: Difference Between The C16022 And C29BR Fifth Wheel Adapters
- Article: Trailer Wiring Diagrams
- Q&A: Difference Between the Curt A16 Fifth Wheel Hitch Head and the E16
- Q&A: Distance Between Bed Rails for Installation of Curt E5 16K Fifth Wheel Hitch
- Q&A: What is the Weight of the Demco 18k Autoslide Fifth Wheel Hitch ?
- Q&A: Removing The Head On Curt Q20 5th Wheel Hitch For The First Time
Craig C.
6/28/2020
Hi there – looking at this answer - I have this hitch and I'm trying to either loosen or torque up those 14mm pilot bolts and I cant really figure out how to get a wrench in there - there's just not enough space...is there a trick I'm not aware of?